Reasons for replacing Amana Water Inlet Valve may include no water, improper temperature water, leaking onto the floor, Amana washer not draining and stuck on sensing fill.
The process involves turning the washer around, turning off the water, unscrewing the hose, removing the control console, disconnecting wires, unclipping wires finally.
How to replace Amana water inlet valve?
Here you will learn to replace the water inlet valve in your washer. But before we start, let’s take a look at the instrument you will need:
- Screwdriver
- Channel-lock pillar
- Bucket
- Brush
- New and replacement inlet valve
- A quarter-inch nut driver
- 5/16 nut driver
- Phillips head screwdriver
- flat head screwdriver
- Needle nose pliers, and channel locks
Now, let’s get started with the process you can try to replace washing machine defective water inlet valve in your washing machine:
- First, you need to unplug your washer from the wall outlet. It will cut the power to your washer.
- Now disconnect the wire supply from the wall.
- Remove the water inlet hoses from the valve by using channel lock pillars. Keep a towel or bucket when you do it.
If there exists water, it will come out while losing it. The towel or bucket will catch the water.
Tips: The water inlet Valve located at the back of the washing machine which you can turn off at clock-wise when needed.
- At that moment, you can check if the filter screens in the water inlet valve have any clogs. If it is, it will be the cause of blocking water flow. So, clean them carefully.
- Now, take the screws out from the washer cabinet to remove the top part of it. You will see the water inlet valve.
- Remove the electrical connectors from the valve by pulling them off gently.
- Remove the mounting screws or bolts which hold the valve in place using a screwdriver or wrench.
8. Remove the old valve from the washer and slide a new water valve into it.
Tips: Do not attempt to clean out an old valve due to the risk of part failure after repair.
How do you test the Amana water inlet valve
To determine if the valve has failed electrically, test for continuity using a multimeter with a resistance measurement between 500 and 1500 ohms. If there is no continuity, the valve needs to be replaced.
To determine if there is a mechanical defect, check for sufficient water pressure by holding the supply lines over a bucket or washtub and observing the water flow.
Weak flow indicates a problem with the supply lines, while a strong flow indicates a restricted valve that needs to be replaced.
Secure the new valve in place using the mounting screws or bolts. Ensure it is placed correctly.
Reconnect the electrical connectors you have removed and the two hoses to the valve.
Re-install the back panel and secure it with the screws or bolts. Reconnect the water inlet hoses carefully and check the fill hoses if the washer is not filling.
Both water inlet hoses must have a rubber washer installed on each end to prevent hoses from leaking.
Amana Product FAQ
Turn on the water supply. Then plug your washer back in.
Test the washer to ensure the new water inlet valve is working suitably.
Source:
https://www.thespruce.com/repair-washing-machine-water-inlet-valve-1824606
Leave a Reply